Explorations in NSFW Stamp Making With A 3D Printer

I really liked this little “octo go fuck yourself” design so I used it to experiment with stamp making. Here, I 3d printed the flexible part of the stamp in Ninjaflex.

middle-finger-octopus

Here’s the design, printed. I’m really not sure this is the best way to go. Ninjaflex doesn’t really absorb ink as well as other materials. I think I may have to experiment with milling it out of eraser material instead.

nsfw-octopus

I started with these 4 items. Just some wood bits from hobby lobby, the 3d printed stamp face, and a screw.

octopus-fuck-you

After the screw was in place, I coated the back of the 3d printed piece, slapped it in place, and clamped it all together with a few clamps.

octopus-stamp

The final result isn’t perfect, but it isn’t too bad either! I may plop this one on etsy for cheap and continue experimenting with better methods.